Whistler PRO-78GXi Bedienungshandbuch

OWNER’S MANUALPRO-78GXiLASER/RADAR DETECTOR

INSTALLATION8Power Cord Connection• Plug the small end of the power cord into the unit’s power jack.• Plug the large end into the vehicle’s cigarett

INSTALLATION9Fuse Replacement - power cordThe lighter socket plug is equipped with a replaceable 2 amp, 3AG fuse located behind the silver tip. To rep

OPERATION10Power On and Self-Test To turn the unit ON or OFF, gently press the center of the Power/Volume button into the side of the unit.Each time y

OPERATION11Speed MuteWhen traveling below the speed selected in option mode, no audio will be given to an alert but the display will still continue to

OPERATIONHighway Mode Highway mode provides full audio warnings any time radar (X, K, Ka, and Safety Warning System - SWS) or laser signals are detect

In City Mode, weak speed/safety radar signals give an initial alarm of two beeps, and then remain quiet until the signal becomes very strong. When the

This alert can be programmed, through the Option Select Mode to: 1. flash for all alarms2. remain on3. turn LEDs off completelyDim/Dark ModesDim/Da

OPERATION15INTELLICORD® ReadyThe INTELLICORD® power cable allows the user to remotely control two of the following detector features (Power On/Off,Cit

OPERATIONManual Entry The unit will save a special location (i.e., a new red light camera or even a “trap”) if you enter it manually. The unit will st

OPERATIONUpdating the DatabaseFollow the steps below to update the Laser-Radar Detector.Step 1: Remove the Laser-Radar Detector from the vehicle and b

If you have questions concerning the operation of this Whistler product please call:CuSTOmer SeRVICE479-273-6012Monday - Friday • 8:00 am - 5:00 pm C

OPERATION18Updating the FirmwareFollow the steps below to update the Laser-Radar Detector.Step 1: Remove the Laser-Radar Detector from the vehicle and

OPERATION19Vehicle Battery Saver ModeThe Vehicle Battery Saver Mode automatically shuts off the detector after 3 hours if the unit has constant power.

OPERATION20X/K Filter Modes Recently, many new products operate on X or K band causing nuisance alerts to radar detectors. Some of these are radar bas

Ka Max Mode Ka Max Mode provides enhanced Ka sensitivity - increased detection. This mode can be selected with or without RSID. See Option Select Mode

OPERATIONLaser Signature ID (LSID)Identify the Laser gun’s pulse rate or PPS (Pulses per Second) that is transmitted by the speed laser gun. LSID may

OPERATIONAdjustable Laser Receiver - continuedAn example of this may be to shorten the first window from .05-1.0 to .05-.90, the second window can be

OPERATION24Safety Warning System™ SWSIn communities where transmitters are located, the Safety Warning System™ can transmit over 60 messages. When an

OPERATION25Option Select Mode - continuedFeatureDisplayShowsTo Change:D=Dark Q=QuietOptionPOWER S1: PowerD or Qto selectRemote Control of Dim, City,

OPERATION26Option Select Mode - continuedKa FILTER Ka FLTR 1 D or Qto selectFilter 1, Filter 2, Filter 3ALERTPERISCOPESLED BLNKD or Qto selectAlert Pe

OPERATION27Stay Alert Feature The Stay Alert Feature is designed to test a driver’s alertness. To engage (when the unit is not alarming): • Press an

INTRODUCTIONDear Whistler Customer,Whistler has utilized its High Performance antenna design and added new features made specifically for the European

RADAR/LASER ALERTS28LASER/RADAR ALERTS Speed Radar Audio/Visual Alerts when X, K or Ka is detected, the band ID and signal strength are displayed. Th

RESET FEATURES29Reset Features All user features can be reset to factory settings. • Remove Power from the unit. • Press and hold the Power and Q

TROUBLESHOOTING30Care and Maintenance Do not spray water, cleaners or polishes directly onto the unit. The spray may penetrate through the openings an

PROBLEM: Unit alarms when vehicle hits bumps.• Check for loose lighter socket; tighten and clean.• Check connections at both ends of the power cord

SPEED MONITORING TECHNOLOGIES32ARE DETECTORS LEGAL? Check with your country’s laws reguarding radar detector ownership and use.It is the responsibilit

SPEED MONITORING TECHNOLOGIES33For best protection, keep these points in mind: • Because the vehicle’s license plate or headlights are the laser gun

SPEED MONITORING TECHNOLOGIES34Radar Facts - ContinuedThis laser/radar detector receives signals from traffic radar guns at X Band (10.500 - 10.550 GH

SPEED MONITORING TECHNOLOGIES35Radar Detector Detectors: VG-2, Spectre - Continuedvulnerable to receive two tickets; one potential for speeding, and t

WARRANTY INFORMATION36Consumer WarrantyThis Whistler product is warranted to the original purchaser for a period of one (1) year from the date of orig

WARRANTY INFORMATION37IMPORTANT: Whistler will not assume responsibility for loss or damage incurred in shipping. Therefore, please ship your unit ins

TABLE OF CONTENTSModel Features Summary ... 4 - 5Installation ...

WARRANTY INFORMATION38In the event repairs cannot be covered by the minimum service fee, you will be contacted by a Whistler technical service special

SPECIFICATIONSRadar Frequencies: 10.500 - 10.550 GHz (X Band) 24.050 - 24.250 GHz (K Band) 33.400 - 36.000 GHz (Ka Superwideband)34.0, 34.3 and 35.5 G

40ACCESSORIESThe following accessories can be ordered from Whistler by calling 1-479-273-6012.Order # Description Price 403774 INTELLICORD®

CORPORATE HEADQUARTERS1716 SW Commerce Dr. Ste. 8PO Box 1760Bentonville, AR 72712Toll Free (800) 531-0004TEL (479) 273-6012 FX (479) 273-2927www.wh

TABLE OF CONTENTS• Adjustable Laser• POP™ Mode Detection• Safety Warning System SWS• Alert Priority• Option Select Mode• Stay Alert™Radar/Laser

FEATURESFeature Listings of PRO-78GXi124126789101113345

FEATURESWhistler’s ergonomic and user-friendly design provides a new level of operating convenience. Special features include: 1. Bracket Release Butt

INSTALLATION6Mounting Guidelines• Mount the unit as low as possible near the center of the windshield. • Do not mount the unit behind wipers, ornam

INSTALLATION7Windshield Mounting• Install the two suction cups and rubber bumper onto the bracket by fitting them into their holes.• Press the sucti